How To Cut Drawer Parts

In this video you will learn how to:

Detailed instructions below the video

Detailed Steps

Cutting your drawer parts to length on the OMGA. What you wanna do first is to calibrate, which is F9. Press F, 9, and START buttons to start the calibration process.

The ______ (at 00:27) will go all the way to the end. The distance from the saw blade to the pusher is 4.194 inches.

Then you wanna enter your dimensions. The first dimension is F4. Then you want to enter your first dimension. Our first dimension would be 13.330. Enter your dimension with the numbers. Press M twice and press Start. The mover moves through that exact dimension and is ready to cut.

_______ (01:20 to 01:21), start the blade. The first thing you wanna do is a trim cut. You wanna make sure you got your one end is a nice flash saw cut. Make sure it’s square against the back grille. Press the up arrow to cut. That’s a trim cut. Then push the pieces in…. and always put the dado towards the back grille. Push the piece against the fence, nice and flush, press the up arrow. You can cut two pieces at a time. Then the same process repeats.