Trash Bin T-Molding

Trash bin tops need to be routed and T-molded before shipping. This gives a nice finished look where the trash bin sits and helps protect that edge when changing the trash bag.

• Start by routing a groove along the interior perimeter with a T-slot cutter making sure to stay level and centered on the material.

• Prepare your molding by running along the inside perimeter to see how much you will need and allow a few extra inches. Cut to length. 

• Using a utility knife cut a notch out of the barbed side of the molding.

• Find the front of the top and tap in the molding making sure to not let it bend over.

• Follow the perimeter while inserting the molding making sure to keep it tight to the corners. 

• When you get to the end trim the molding to about an inch past the start.

• Notch the barbed side again so you can insert the end up to the starting point.

• Use a utility blade to cut through both ends to make a tight, straight joint.

• Trim along the top and bottom face if necessary.